UBOAT How to Use Mapwork (Manual TDC Tutorial)

Welcome, guideoui.com visitors. In this guide, We try to focus on UBOAT How to Use Mapwork. While writing this guide, we pick up many pieces of information from several sites for you. We hope that this guide will help you.

How to Use Mapwork (Manual TDC Tutorial)

THE METHOD

Alternative Video

Used mixed measurements, just so you know, it’s the measurement setting that recommended as measuring the speed the way that done works out mathematically.

– Before the video starts, established the speed of the contact by placing a mark on it and using the chronometer and time compression to wait 3 minutes, then placed another mark. The distance travel in 3 minutes translates to Knots. For example, say I place a mark, start the chrono and wait 3 minutes. I place a mark on the contact at the end of 3 minutes, then measure the traveled distance and get 2km (2000m) this translates to 20 Knots.

Say the distance measured is 400m, then the speed of the contact is 4 Kn. What if the measurement is 450m? Or 750m? Then round up, the AI in these games never really go in between, so it’s always safe to round up. So I would chose 5kn, or 8kn. If you want to verify the speed on the contact, and have a nice broadside visual, I recommend backing up your speed measurement with the use of the periscope and chronometer.

– When measuring the angle produced when the course of the target crosses your “compass” line, you measure the angles on the top half, not the bottom half’s angles. If a target is going North, East, North-East, South-East, or South the angle you measure is the true course, no math needed. If the target’s true course is technically greater than 180 degrees (It’s going South-West, West or North-West), you use the simple math problem 360-X= TC. 360 Is the full compass circle. X is the measured angle. TC, or True Course is the Answer.

A PRACTICAL EXAMPLE

When you draw your first line for use as a compass reference, you don’t even need to use a protractor. It can just be a basic North-South line, but I like using the protractor. All you’re using the line for is to produce an angle. Here is an example of me using this method in action.

TDC TOOLS EXAMPLE

So now that I understand how to use the AOB tool in game, will share with you what have been learned.

The AOB (Labeled as “Course” Tool) works off of what you see relative from your boat.

You have a 360 degree compass that represents view points from your boat, and a plastic strip that points to where your target is. The part of the tool you manipulate is supposed to mimic the Angle on the Bow that you see. (Hence why the description says to match what you see.)

Angle on the Bow is what the ship would see you at. So if you are standing on a ship and see a Uboat at 90 degrees to the right (starboard), the Uboat would say your AOB is 90 Starboard. If you see the Uboat at 270 left (port) then the Uboat would say your AOB is 90 port. Finding AOB with this tool, will then tell you the course of the target.

Measuring the the course before hand, like I did, provides a point of reference to use when using this tool.

Similar Posts:


Written by CPL. Rich8

Leave a Reply

Your email address will not be published.